Skip to content
Hands lifting a scaled, food-flecked filter out of an open dishwasher with the lower rack pulled out

Dishwasher Repair in Rockford, IL

Updated

Get a repair price

A local technician calls back with a time and a price before any work starts.

Rather talk? Call (815) 800-0677 or text us.

Short answer

Dishwasher repairs average $225, mostly $175 to $325 (Angi, 2026). Standing water is the most common call: clean the filter, check the drain hose, and on a new install make sure the knockout plug in the disposer was removed (Whirlpool). White film is usually hard water; GE says hard-water buildup can damage dishwasher components over time, and Rockford's water measured a median of about 22 grains per gallon in state samples.

All 2026 repair prices

Ready for a price?

Call, text, or send the form. A local technician gives you a price before any work starts.

Not draining

Whirlpool's checks: remove and clean the filter, look for a kinked or clogged drain hose between the dishwasher and the sink, make sure a connected disposer is clear and its knockout plug was removed on a new installation, and clear the air gap if you have one (Whirlpool). KitchenAid shows F9E1 for a long drain (KitchenAid) and Bosch shows E24 or E25 for a blocked drain pump or a kinked hose (Bosch).

Leaks and the "water in the base" codes

Bosch's E15 means its safety switch has detected water in the base and the leak protection has activated; Bosch says to turn off the water inflow and contact support (Bosch). KitchenAid's F8E4 is water detected in the drip tray (KitchenAid). A water-in-base code means find the leak first; resetting it only hides it.

White film and spots: Rockford water

GE says white film on glasses and the tub is most often seen in hard-water areas, partly because modern detergents are phosphate-free, and that over time hard-water buildup can cause damage to dishwasher components. GE's fixes are a dishwasher cleaner or a citric acid cycle, a rinse aid, and a water softener (GE, GE, GE). Bosch dishwashers can flag E12, limescale build-up in the heat pump (Bosch). If your model has a water hardness setting, use your town's number from the hardness table.

What the repair usually is

  • Door latch: $75 to $175
  • Drainage problem or clog: $100 to $250
  • Leak repair: $100 to $250
  • Heating element: $150 to $300
  • Pump: $150 to $350
  • Control board: $200 to $400
  • Motor: $250 to $600

From Angi. InterNACHI puts a dishwasher's expected life at 9 years (InterNACHI).

Set your dishwasher for Rockford water

Illinois EPA's lab tested City of Rockford water 13 times between 2022 and 2026, and the median result was 377 mg/L of total hardness, about 22 grains per gallon (Illinois EPA). The USGS calls anything over 180 mg/L very hard (USGS). The Rockford Water Division gives its own range as 9 to 21 grains per gallon across its 39 wells (City of Rockford). That is the number a dishwasher hardness setting asks for. GE's SmartDispense models take it from a test strip (GE), and a Bosch with a built-in softener flags E12 when limescale builds up in the heat pump (Bosch). If your model has a hardness setting and it is still on the factory default, set it to your water's number (Rockford's median is about 22 grains) before you book a repair for cloudy glasses. Keep the rinse aid full too; GE says it lets water sheet off the dishes instead of drying into spots (GE).

Dishwasher calls in Rockford

Most Rockford dishwashers sit in kitchens much older than the machine. 46.5% of the city's homes were built before 1960 and the median dates from 1963 (Census ACS 2020-2024), so many dishwashers were added to a kitchen that was not planned for one. Where it drains through a garbage disposer, the disposer knockout plug and the drain hose are the first checks on a not-draining call; they are above and in dishwasher not draining.

45.1% of Rockford households rent (Census ACS). That is the highest renter share of the 16 places on this site with enough homes to compare. If the appliance came with the unit, it belongs to the owner, so loop in the landlord or property manager before booking. If the old one is going out, the city's certificate rule is for appliances that contain refrigerant, so it does not apply to a dishwasher; bulk items go to the curb on your regular garbage day at the bulk refuse rates in the city fee schedule (City of Rockford). Before you replace it, compare the appliance repair cost with a new one.

Where this is done

Dishwasher Repair across Rockford and Winnebago and Boone counties. Prices for every appliance are on the appliance repair in Rockford homepage. Each town page has its own local rules and numbers; the rest are on the service area page.

Common questions

Dishwasher Repair: questions

Why is there water in the bottom of my dishwasher?

Usually a clogged filter or drain hose, a blocked disposer, or on a new install a knockout plug that was never removed. Those are Whirlpool's first checks.

What does E15 mean on a Bosch dishwasher?

Bosch says E15 means the safety switch has detected water in the base and the leak protection system has activated. Turn off the water inflow and have the leak found.

Why do my glasses come out cloudy?

Often hard water. GE says white film is most often seen in hard-water areas, recommends rinse aid and a citric acid cycle, and says hard-water buildup can damage dishwasher components over time.

How much does dishwasher repair cost?

Angi's 2026 guide: most repairs $175 to $325, averaging $225. A pump is $150 to $350 and a control board $200 to $400.

Dishwasher trouble?

Tell us the appliance, the brand, the model number if you have it, and what it is doing. A local technician calls back with a time and a price before any work starts.